Det kan vara så att du får köra en "ordentlig" cmos clear.
Enligt dfi (funka för mig)
___________________________________________________
Remove power from the rig by pulling the plug or switching the PSU off.
* Move the PC Speaker jumper to the ON position. - kanske inte nödvändigt för dig
Remove the Battery.
Move the CMOS jumper to CLEAR.
Press the Start Button on the case or motherboard to drain the capacitors.
You may leave the board in this condition for as long as it takes to clear the CMOS. If a short 30 second clear or a 15 minute clear doesn't work, try an 8 hour clear then a 24 hour clear.
Plug in a PS2 Keyboard.
Put one stick of RAM in the top orange slot marked DIMM2.
Move the CMOS jumper to Normal.
Replace the Battery.
Press and hold the Insert Key on the Keyboard.
Apply power to the rig by plugging the power in or using the switch on the PSU.
Press the Start Button to power the rig up.
When you hear the BEEP, release the Insert Key and press the Delete Key on the Keyboard.
Once you enter the BIOS set the DATE and TIME then Load Optimized Defaults.
Save and Exit.
Enter the BIOS again and set it up the way you want for your particular rig.
NEVER load any saved CMOS settings from CMOS Reloaded once you have a new BIOS installed.
_____________________________________________________________
