* [10053] Software caused connection abort pga. router?

Error Message:

Software caused connection abort.

Explanation:

This error can occur when the local network system aborts a connection, such as when Winsock closes an established connection after data retransmission fails (receiver never acknowledges data sent on a datastream socket).

User Action:

Check the following: 1. Ping the remote host you were connected to. If it doesn't respond, it might be offline or there might be a network problem along the way. If it does respond, this problem might have been a transient one (so you can reconnect now), or the server application you were connected to might have terminated (so you might not be able to connect again). 2. Ping a local host to verify that your local network is still functioning (if on a serial connection, see next step). 3. Ping your local router address. If you are on a serial connection, your local router is the IP address of the host you initially logged on to using SLIP or PPP. 4. Ping a host on the same subnet as the host you were connected to (if you know of one). This will verify that the destination network is functioning. 5. Type tracert at the command prompt to determine the path to the host you were connected to. This won't reveal too much unless you know the router addresses at the remote end, but it might help to identify if the problem is somewhere along the way.