Problem med CHKDSK
Hej!
Har fått ett litet problem som gör så att det inte går att defragmentera; varje gång man försöker så står det att man måste köra en "scandisc" för det finns en "smutsig bit" på disken och kan därför inte defragga. Dessutom så går det inte att köra scandisc heller
Läste FAQ:en för diskeeper som jag använder och där stod det:
When I try to select a partition with Diskeeper, it says, ''Diskeeper has detected that CHKDSK is scheduled to run on the volume: Please run CHKDSK /F.'' What is the problem?
The ''dirty bit'' is set on this partition. The dirty bit is single point of entry that is changed from a 0 to 1 to ensure that CHKDSK /F will be run during the next restart of the system. You can check this by typing CHKNTFS C: (assuming that the C: partition is the one in question) at the Command Prompt. When you reboot the system, CHKDSK should run. When it runs, the dirty bit setting will be reverted to its original value. If it does not run, the dirty bit will remain set and thus you will continue to see the message.
If CHKDSK does not run during the restart, you are probably running a software licensing service called ''Crypkey Service'', ''Crypkey License,'' and possibly a driver ''NetworkX'' that lock the system drive. The ''Crypkey'' portion provides key-based copy protection and the ''NetworkX'' provides a means of transporting it across locally connected networks. Here is a link to the Microsoft Knowledge Base article on this: http://support.microsoft.com/support/kb/articles/Q176/5/04.AS...
The service and driver must be stopped and disabled, and then the CHKDSK /F can run when the system restarts. The software protected by this system will not operate correctly until the service and driver are restarted and enabled.
We have also received reports of a Kensington Mouse driver that inhibits the ability of CHKDSK /F to run. If you are certain that you are not using Crypkey, this may be the issue.
By request of Microsoft, Diskeeper will not run on a partition that has the dirty bit set. The dirty bit is not something to be taken lightly; it is the only way that Windows NT has to attempt to make sure that you do not get into serious trouble with a partition.
If none of the above applies to your current configuration, we recommend that you do a clean installation of Windows NT in a separate directory and reboot to that installation. That will allow CHKDSK /F to run and clear the dirty bit.
Har provat att lösa det på dom sätt som beskrivs, men kan inte hitta någon servicetjänst som heter det dom nämner. Så det känns som det enda ja kan göra är att installera XP på en annan partion än C: och lösa det den vägen...och i så fall:
1. Påverkas min orginalconfig när ja kör en till installation av Windows?
2. Någon som vet ett smidigare sätt att lösa detta problem?
3. Kan man skita i problemet och använda något annat defrag-program?
Tack på förhand/
Mattias
