FreeNAS 0.72 sparar config till floppy - jag vill spara till USB istället.

Using device=/dev/fd0 fstype=msdos to store configuration.

$ dmesg
Copyright (c) 1992-2010 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.3-RELEASE-p3 #0: Tue Nov  2 22:42:55 CET 2010
    root@dev.freenas.org:/usr/obj/freenas/usr/src/sys/FREENAS-i386 i386
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Celeron(R) CPU 2.40GHz (2392.26-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf29  Stepping = 9
  Features=0xbfebfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
  Features2=0x4400<CNXT-ID,xTPR>
real memory  = 804192256 (766 MB)
avail memory = 584663040 (557 MB)
ACPI APIC Table: <PTLTD  	 APIC  >
ioapic0 <Version 2.0> irqs 0-23 on motherboard
wlan: mac acl policy registered
kbd1 at kbdmux0
cryptosoft0: <software crypto> on motherboard
padlock0: No ACE support.
acpi0: <PTLTD   RSDT> on motherboard
acpi0: [ITHREAD]
acpi0: Power Button (fixed)
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x1008-0x100b on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
vgapci0: <VGA-compatible display> mem 0x88000000-0x8fffffff,0x80000000-0x8007ffff irq 16 at device 2.0 on pci0
agp0: <Intel 82845M (845M GMCH) SVGA controller> on vgapci0
agp0: detected 380k stolen memory
agp0: aperture size is 128M
uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0x1800-0x181f irq 16 at device 29.0 on pci0
uhci0: [GIANT-LOCKED]
uhci0: [ITHREAD]
usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801DB (ICH4) USB controller USB-B> port 0x1820-0x183f irq 19 at device 29.1 on pci0
uhci1: [GIANT-LOCKED]
uhci1: [ITHREAD]
usb1: <Intel 82801DB (ICH4) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb1
uhub1: 2 ports with 2 removable, self powered
uhci2: <Intel 82801DB (ICH4) USB controller USB-C> port 0x1840-0x185f irq 18 at device 29.2 on pci0
uhci2: [GIANT-LOCKED]
uhci2: [ITHREAD]
usb2: <Intel 82801DB (ICH4) USB controller USB-C> on uhci2
usb2: USB revision 1.0
uhub2: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb2
uhub2: 2 ports with 2 removable, self powered
ehci0: <Intel 82801DB/L/M (ICH4) USB 2.0 controller> mem 0xc0080000-0xc00803ff irq 23 at device 29.7 on pci0
ehci0: [GIANT-LOCKED]
ehci0: [ITHREAD]
usb3: EHCI version 1.0
usb3: companion controllers, 2 ports each: usb0 usb1 usb2
usb3: <Intel 82801DB/L/M (ICH4) USB 2.0 controller> on ehci0
usb3: USB revision 2.0
uhub3: <Intel EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb3
uhub3: 6 ports with 6 removable, self powered
umass0: <Generic Mass Storage, class 0/0, rev 2.00/1.42, addr 2> on uhub3
pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib1
fxp0: <Intel 82801DB (ICH4) Pro/100 VE Ethernet> port 0x2080-0x20bf mem 0xc0100000-0xc0100fff irq 20 at device 8.0 on pci2
miibus0: <MII bus> on fxp0
inphy0: <i82562ET 10/100 media interface> PHY 1 on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp0: Ethernet address: XXXXXXXXXXXXXXXXXXX
fxp0: [ITHREAD]
uhci3: <VIA 83C572 USB controller> port 0x20c0-0x20df irq 21 at device 9.0 on pci2
uhci3: [GIANT-LOCKED]
uhci3: [ITHREAD]
usb4: <VIA 83C572 USB controller> on uhci3
usb4: USB revision 1.0
uhub4: <VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb4
uhub4: 2 ports with 2 removable, self powered
uhci4: <VIA 83C572 USB controller> port 0x20e0-0x20ff irq 22 at device 9.1 on pci2
uhci4: [GIANT-LOCKED]
uhci4: [ITHREAD]
usb5: <VIA 83C572 USB controller> on uhci4
usb5: USB revision 1.0
uhub5: <VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb5
uhub5: 2 ports with 2 removable, self powered
ehci1: <VIA VT6202 USB 2.0 controller> mem 0xc0101000-0xc01010ff irq 23 at device 9.2 on pci2
ehci1: [GIANT-LOCKED]
ehci1: [ITHREAD]
usb6: EHCI version 1.0
usb6: companion controllers, 2 ports each: usb4 usb5
usb6: <VIA VT6202 USB 2.0 controller> on ehci1
usb6: USB revision 2.0
uhub6: <VIA EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb6
uhub6: 4 ports with 4 removable, self powered
xl0: <3Com 3c905B-TX Fast Etherlink XL> port 0x2000-0x207f mem 0xc0101400-0xc010147f irq 22 at device 10.0 on pci2
miibus1: <MII bus> on xl0
xlphy0: <3Com internal media interface> PHY 24 on miibus1
xlphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
xl0: Ethernet address: XXXXXXXXXXXXXX
xl0: [ITHREAD]
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0x1860-0x186f at device 31.1 on pci0
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
acpi_tz0: <Thermal Zone> on acpi0
acpi_tz0: _CRT value is absurd, ignored (6280.3C)
acpi_button0: <Power Button> on acpi0
speaker0: <PC speaker> port 0x61 on acpi0
fdc0: <floppy drive controller> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on acpi0
fdc0: [FILTER]
cpu0: <ACPI CPU> on acpi0
p4tcc0: <CPU Frequency Thermal Control> on cpu0
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xe0000-0xeffff pnpid ORM0000 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
atkbd0: [ITHREAD]
ppc0: parallel port not found.
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250 or not responding
sio0: [FILTER]
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
ukbd0: <Logitech HID compliant keyboard, class 0/0, rev 1.10/1.80, addr 2> on uhub2
kbd2 at ukbd0
uhid0: <Logitech HID compliant keyboard, class 0/0, rev 1.10/1.80, addr 2> on uhub2
Timecounter "TSC" frequency 2392255196 Hz quality 800
Timecounters tick every 1.000 msec
ipfw2 (+ipv6) initialized, divert loadable, nat loadable, rule-based forwarding disabled, default to accept, logging limited to 5 packets/entry by default
iSCSI boot driver version 0.1.3
md0: Preloaded image </mfsroot> 188743680 bytes at 0x80f134e4
ad0: DMA limited to UDMA33, controller found non-ATA66 cable
ad0: 190782MB <SAMSUNG SP2014N VC100-33> at ata0-master UDMA33
acd0: CDROM <SAMSUNG CD-ROM SC-148C/B103> at ata1-master UDMA33
(probe0:umass-sim0:0:0:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 
(probe0:umass-sim0:0:0:0): CAM Status: SCSI Status Error
(probe0:umass-sim0:0:0:0): SCSI Status: Check Condition
(probe0:umass-sim0:0:0:0): UNIT ATTENTION asc:28,0
(probe0:umass-sim0:0:0:0): Not ready to ready change, medium may have changed
(probe0:umass-sim0:0:0:0): Retrying Command (per Sense Data)
da0 at umass-sim0 bus 0 target 0 lun 0
da0: <USB2.0 Flash Disk 8.07> Removable Direct Access SCSI-2 device 
da0: 40.000MB/s transfers
da0: 242MB (497662 512 byte sectors: 64H 32S/T 242C)
Trying to mount root from ufs:/dev/md0
ukbd0: at uhub2 port 1 (addr 2) disconnected
ukbd0: detached
uhid0: at uhub2 port 1 (addr 2) disconnected
uhid0: detached
This module (opensolaris) contains code covered by the
Common Development and Distribution License (CDDL)
see http://opensolaris.org/os/licensing/opensolaris_license/
WARNING: ZFS is considered to be an experimental feature in FreeBSD.
ZFS WARNING: Recommended minimum kmem_size is 512MB; expect unstable behavior.
             Consider tuning vm.kmem_size and vm.kmem_size_max
             in /boot/loader.conf.
ZFS filesystem version 3
ZFS storage pool version 13
WARNING: /mnt/Lagring200Gb was not properly dismounted