Editera en viss fil
Hej,
På vårt företag använder vi tunna klienter från HP som sedan ansluter in till terminalservrar.
Dessa tunna klienter kör ett Linux operativsystem som heter ThinPro.
Jag försöker att editera en fil enligt en manual från HP, men den filen låter sig inte ändras hur jag än gör.
Filen i fråga ligger här: /proc/net/ipeak0/config/system
Försöker jag skapa en ny fil i samma katalog via guit texthanterare så får jag till svar "no such file or directory"
Efter att ha googlat lite så verkar det som att filer som ligger i denna sökväg inte går att editera. Stämmer det? Varför föreslår i så fall HP att man ska ändra däri?
Jag klistrar in allt som står på sidan här nedan så ni kan se vad det står (mycket text)
--------------------------------------------------------------------------------------------------------
system
Description
The /proc/net/<ipeak0/1/2>/config/system file specifies the following parameters:
• opMode: Set the operational mode of HP Velocity.
• liveTcpMode: Set the mode HP Velocity uses to provide optimization.
• liveWiFiEnable: Accelerate application flows by leveraging Wi-Fi multimedia standards to minimize latency and
prioritize HP Velocity traffic. This ensures that HP Velocity-protected flows experience lower latency and jitter, and
higher throughput.
• ipOptionMark: Use the IP option beacon (0x880477FB) for UDP flows.
• tcpOptionMark: Use the TCP option beacon (0x01000000 and 0x00000000) for TCP flows.
• mtu: The MTU that can be processed within the network.
Read / Write
• Read / Write: Any single value using a string with the format <parameter> = <value>.
Parameters
Table 22: ./config/system parameters
Note: When the IP option beacon (ipOptionMark) or TCP option beacon (tcpOptionMark) setting is enabled, HP Velocity
adds up to 4 bytes of data to IP or TCP headers. This is in compliance with RFC 791 and RFC 793. Some applications might
not be compliant with RFC 791 or RFC 793, and as a result might not be able to process IP or TCP Option beacons. If this
occurs, disabling the IP option beacon or TCP option beacon setting should resolve the issue.
Mac mini 2018 with external GPU over Thundelbolt 3 - Radeon RX580