Problem med Windows installationen

har du installerat ev SATA-drivrutiner? (om du har SATA-diskar)

men tryckt på f6 ibörjan för att kunna installera på sata eller ditt moderkort kanske inte behöver det?

hmmm iof behövde inte jag sata drivisar till min servers asrock bräda!! ska kolla vilket chipset det är på mitt!!

VIA p4m800pro

moderkortet hette tydligen det samma

har du haft problem innan eller var det första gången du installerade?

när jag hade ett asus moderkort så var jag tvungen att ha drivisar på disket till det o då tryckte jag f6 efter uppstart det står ju längst nere en stund efter att den kontrolerat maskinvaran eller vad det nu står! sen kommer det en förfrågan att man ska sätta i disketten med drivrutiner!!! dsen fortlöper det som vanligt!!

ur den olästa manualen

Before you install OS into the SATA hard disk, you need to check and
ensure the configuration of the OnBoard IDE Operate Mode option in
BIOS setup is correct according to the condition of your system. For
the configuration details, please refer to the instruction on page 27.

PAGE 27

OnBoard IDE Operate Mode
Please select [Compatible Mode] when you install legacy OS (Windows
ME / 98SE) into SATA device. If you install legacy OS into IDE HDD while
SATA devices are used, you also need to select [Compatible Mode].
If native OS (Windows 2000 / XP) is installed into SATA device, please
select [Enhanced Mode]. You also need to select [Enhanced Mode]
while native OS is installed into IDE HDD and SATA devices are used.
If you do not install any SATA device, please also select [Enhanced Mode]
no matter you use legacy OS or native OS for the system.
Please note that the following options will be varied depending on the
“OnBoard IDE Operate Mode” ([Compatible Mode] or [Enhanced
Mode]) that you selected.
When [Enhanced Mode] is selected:
OnBoard IDE Controller
You may enable either the primary IDE channel or the secondary IDE channel.
Or you may enable both the primary and the secondary IDE channels by
selecting [Both]. Set to [Disabled] will disable the both. Configuration options:
[Disabled], [Primary], [Secondary], [Both].
When [Compatible Mode] is selected
Combined Mode Option
It allows you to select between [Pri IDE + SATA] and [SATA + Sec IDE]. If
it is set to [Pri IDE + SATA], then the secondary IDE will not work. Likewise,
if it is set to [SATA + Sec IDE], then the primary IDE will not work.
®
Because Intel ICH5 south bridge only supports four IDE devices
under legacy OS (Windows ME / 98SE), you have to choose either
[Pri IDE + SATA] or [SATA + Sec IDE] when the installed SATA device
is used with legacy OS.
2727
27
2727

har du satt att den ska boota från hd med i boot sekvens? eller boot prioritet