Hej,
Om jag aktiverar XMP får jag 4GB i minne som går i 1600Mhz istället för 1333Mhz.
Windows rapporterar 8GB (4GB usable)
Om XMP är inaktiverat får jag 8GB minne som går i 1333Mhz.
CL blir även 9 istället för 7 med XMP avslaget.
Jag har inte provat att ställa in något manuellt då jag aldrig gjort det förut.
Tips någon?
Moderkort: GA-P55A-UD4 BIOS F9 (F15 finns)
Minne: Corsair 4GB (2x2048MB) CL7 1600Mhz XMS3
Windows 7 64-bit Ultimate
Här är profilen:
[Enthusiast / Certified Profile [Enabled]]
Module VDD Voltage Level: 1.65 V
CAS# Latencies Supported: 6, 7
Minimum SDRAM Cycle Time (tCKmin): 1.250 ns (800.0 MHz)
Minimum CAS Latency Time (tAAmin): 8.750 ns
Minimum RAS# to CAS# Delay Time (tRCDmin): 10.000 ns
Minimum Row Precharge Delay Time (tRPmin): 8.750 ns
Minimum Active to Precharge Delay Time (tRASmin): 25.000 ns
Minimum CAS Write Latency Time (tCWLmin): 8.750 ns
Minimum Write Recovery Time (tWRmin): 15.000 ns
Minimum Active to Active/Refresh Delay Time (tRCmin): 50.625 ns
Maximum tREFI Time (Average Periodic Refresh Interval): 7.750 us
Minimum Refresh Recovery Delay Time (tRFCmin): 110.000 ns
Minimum Internal Read to Precharge Command Delay Time (tRTPmin): 7.500 ns
Minimum Row Active to Row Active Delay Time (tRRDmin): 7.500 ns
Minimum Four Activate Window Delay Time (tFAWmin): 37.5 ns
Minimum Internal Write to Read Command Delay Time (tWTRmin): 7.500 ns
Supported Module Timing at 800.0 MHz: 7-8-7-20
Read to Write CMD Turn-around Time Optimization: No adjustment
Write to Read CMD Turn-around Time Optimization: No adjustment
Back 2 Back CMD Turn-around Time Optimization: No adjustment
System Command Rate Mode: 2N